Wtw6200sw0 service manual

If this test mode has been entered successfully, all indicators on the console are illuminated for 5 seconds with 88 showing in the Estimated Time Remaining two-digit display. During the 5 second wait time with 88 showing in the display, press the same button once. You should be in manual test mode.

If the button is not pressed within 5 seconds, the automatic test mode begins. Console can have up to two of these indicators on at the same time when the tub is not moving. Open the lid and rotate the basket by hand. The Wash, Rinse, and Spin indicators should toggle on and off according to the direction the tub is being turned.

The lid locks and the lid lock indicator turns on. Press again and motor turns off. Also read here: Whirlpool Cabrio stopped working error code F51 Jake. I have already done the manual thing. The lights light correctly when I turn the bowl manually in manual mode.

It did work for one spin cycle after I reset all connectors on control module but just died again witht the F50 error.

Tried to reseat connectors again with no luck. I'll ask Eric if he knows. Jake said:. Click to expand Ok, sounds good, yes keep us posted. They replaced the control board. Working right now. Sounds good. Thanks for the update, that will help others. Here's the control module for your model in case others need it: Main Control Board W Order now for same day shipping. Rob Morrison Premium Member. Hi Jake! I'm getting the error codes F50 and F51 on my Whirlpool Cabrio.

I have check all connections and done the manual spin tests and motor checks as well as inspected all connections. What is my next move? I need the model number of your washer Rob. Click here: Appliance Parts at RepairClinic.

Then you will see a link that says: Help me find my model number. I'm attaching a service bulletin on this issue below.

It also says to order part number W like the previous poster orion did above. Now the manufacturer has replaced part number W with part number W like I posted above. Hey Jake, I went ahead and replaced the control board as I felt I'd exhausted every other possibility and I'd seen an early post from you where that had worked.

That did the trick. Thanks for your help. Excellent, good job Rob, glad the new control board fixed it. After your payment is complete you will be redirected to the document retrieval section. I have read and agreed to the Terms of Service. Most modern browsers and operating systems are able to display PDF documents. If you operate an older device, you will need Adobe Acrobat Reader to view these documents. Adobe Acrobat Reader is available as a free download.

Customer Reviews:. Tub Capacity as per Manufacturer Specifications in cubic feet : The manufacturers began using cubic feet capacity numbers only recently.

Previously, they used relative terms such as "Large" or "Extra Capacity" or laundry weight e. Others referred to capacity in terms of water used. Even washers available today do not have capacity written in the manual because the same manual can be used across multiple models. Once the washer is no longer sold, the sales literature is discarded and capacity information often lost.

Analyzing washers and their components, searching through old technical information and sales literature, and determining their capacity is a labor intensive and time-consuming task and we are far from finished. A small charge will help us continue our research. Consider this: if you were to spend more than few minutes looking for tub capacity on the internet, you would be earning LESS than minimum wage.

Because a tub is not exactly a cylinder. The edge where bottom connected to the wall is not at 90 degree angle but smooth and rounded. The water line is not clearly marked and the bottom is not always flat.

Finally, an agitator also takes capacity away from the tub. This method can be used as a crude estimate but we do not recommend using it for comparisson when shopping for a new washer. Determine your top load washer tub capacity by taking two simple measurements: 1. Use the ruler to measure the depth of the tub indicated by the red line on the diagram 2.